|
Rear Axle Seal for 2001 and newer E-Z-GO gas and electric model ST 480 and Woods Boundary and MAV 480 Vehicles.
Part Number: BE22-190
Retail: |
$33.68 |
On Sale: |
$17.43 |
You Save: |
49% |
|
|
|
NO LONGER AVAILABLE +++ Electrical Component Box for 1992 and newer Club Car gas model DS.
Part Number: EL44-400
|
|
|
48 Volt Solenoid for 2014 and newer Yamaha electric model YDR "The Drive" +++ 2010 and newer E-Z-GO TXT model with Curtis brand controller.
Part Number: SO22-125
|
|
|
Insulating Resistor Board for 1972 to 1975 Harley Davidson models DE, DE4 and 1977 to 1983 models BE3, DE4 and DEX4.
Part Number: SP11-252
Retail: |
$25.73 |
On Sale: |
$25.73 |
|
|
|
NO LONGER AVAILABLE +++ Rear Coil Spring for E-Z-GO Marathon 2 cycle gas.
Part Number: ST22-401
|
|
|
None Available At This Time +++ Good Used Rear Coil Spring for E-Z-GO Marathon 2 cycle gas.
Part Number: ST22-401U
|
|
|
Inductive Throttle Sensor for 1994-1/2 and newer E-Z-GO with DCS or PDS systems.
Part Number: SP22-400
Retail: |
$203.95 |
On Sale: |
$126.36 |
You Save: |
39% |
|
|
|
CURRENTLY ON BO until end of August +++ Vacuum Control Valve for 1985 to 1995 Yamaha G2, G5, G8, G9 and G11 with 4 cycle engine +++ Also for 1986 to 1997 Taylor-Dunn model R-680 engine.
Part Number: EN99-940
|
|
|
NO LONGER AVAILABLE +++ General Electric Factory Original 10 Spline Armature for 1981 to 1986-1/2 E-Z-GO 2 hp Motor +++ Also others with 10 spline 5BC48JB644 motors.
Part Number: MT22-022
|
|
|
NO LONGER AVAILABLE +++ Professionally Rebuilt 10 Spline Armature for 1981 to 1986-1/2 E-Z-GO 2 hp Motor... Also others with 10 spline 5BC48JB644 motors.
Part Number: MT22-023
|
|
|
Air Canister Decal for 1983 to 1995 Columbia Par Car.
Part Number: FU11-780
|
|
|
Motor Output Shaft Seal for 1980 to 1984 Club Car with 16 spline General Electric Motor.
Part Number: BE44-300
|
|
|
Replacement Accelerator Ball Joint and Stud for 1976 to 1994 E-Z-GO Pre Medalist Marathon X440 and X444 models.
Part Number: SP22-502
|
|
|
Electric Motor Bearing on Harley Davidson +++ E-Z-GO +++ Club Car +++ Cushman +++ Taylor-Dunn +++ Nordskog +++ Yamaha and others with General Electric, Baldor or Hitachi motors.
Part Number: BE11-261
|
|
|
Motor Input Shaft Seal on 1980 to 1984 Club Car with 16 spline Hitachi motor from Club Car serial number A8003-15260 to A8405-50906... Most likely will fit 16 spline Hitachi motors used on Yamaha and others.
Part Number: BE44-150
|
|
|
Lower Fork Stem Neck Bearing with built in Seal for 1985 to 1988 Columbia Par Car three wheel models G3 and E3.
Part Number: BE11-276
|
|
|
Rear Axle Seal for 1993 and newer Columbia Par Car BC2, BC3 and BC4 Burden Carriers.
Part Number: BE11-760
|
|
|
NO LONGER AVAILABLE +++ Speed Control Module Kit for 1986 and newer Columbia Par Car electric four wheel model E4S with solenoid speed control systems.
Part Number: SP11-432
|
|
|
Canister type 4 mf (micro farad) Capacitor for 36 volt Lester charger models 16500, 14100, 9700 and 7710 built after December of 1990. Used on Club Car, E-Z-GO, Nordskog and others.
Part Number: BT11-150
|
|
|
Replacement Governor Rod Assembly for 1979 to 1986 Yamaha G1 and 1986 Yamaha G3 +++ Also Replacement Oil Injection Rod on E-Z-GO with 2 cycle engine with oil injection.
Part Number: FU22-660
|
|
|
NO LONGER AVAILABLE +++ Camber Adjuster for Inner A-arm on 1988 to 2007 Columbia Par Car models P4G, P4E, G4S, E4S, GU4, EU4, C6E, C6G, GD4 and ED4.
Part Number: ST11-340
|
|
|
Forward and Reverse Switch Decal for Cushman GC300 and GC400 Gran Cushman Golfsters with floor shift style F&R switches.
Part Number: BD33-400
|
|
|
Front Brake Hose for All Melex models 666 and 667 and industrial carts with hydraulic brakes.
Part Number: BK66-120
|
|
|
Rear Brake Hose for Melex models 666 and 667 and other industrial carts with hydraulic brakes.
Part Number: BK66-130
|
|
|
Two Terminal, 110 db, 12 Volt Horn used as O.E.M. (Original Equipment Manufacture) on Motrec +++ Will also work on many other 12 volt carts.
Part Number: AC11-250
|
|
|
NOW AVAILABLE +++ Left Drivers Side Rear Axle for 1997 and newer Taylor-Dunn models SS-536 and MX-600 with Dana differential.
Part Number: AX88-400
|
|
|
Right Passenger Side Rear Axle for 1997 and newer Taylor-Dunn models SS-536 and MX-600 with Dana differential.
Part Number: AX88-410
|
|
|
Resistor Mounting Bolt for 1974 and newer Taylor-Dunn model SS-534 Step Saver +++ Also GT-360 and GT-370 speed control board and others.
Part Number: SP88-152
|
|
|
Keps Style Resistor Mounting Nut for 1974 and newer Taylor-Dunn model SS-534 Step Saver +++ Also GT-360 and GT-370 speed control board and others.
Part Number: SP88-153
|
|
|
Brake Lever Actuator for 1953 to 1965 Cushman Industrial and Golfer 3 wheel electric models 1953 model 730-3 through 1957 model 730-35 +++ 1954 model 731-6 through 1959 model 731-104 +++ 1960 to 1965 Truckster series 780 +++ 1961 to 1964 Cushman series 735 Golfster numbers 878915 and 879717 +++ 1978 to 1984 Minute Miser.
Part Number: BK33-000
|
|
|
1953 to 1965 Cushman Industrial and Golfer 3 wheel electric models 1953 model 730-3 through 1957 model 730-35 +++ 1954 model 731-6 through 1959 model 731-104 +++ 1960 to 1965 Truckster series 780 +++ 1961 to 1964 Cushman series 735 Golfster numbers 878915 and 879717 +++ 1978 to 1984 Minute Miser.
Part Number: BK33-002
|
|
|
Brake Shoe Heel Pin for 1976 to 1995 Cushman Titan, gas and electric models +++ 1965 to 1994 Cushman Turf Truckster and 1965 to 1994 Haulster +++ 1990 to 1994 GT1 and F2 and F2J up to 1994 +++ Other Cushman models as well..
Part Number: BK33-022
|
|
|
Brake Adjustment Pin for 1976 to 1995 Cushman Titan, gas and electric models +++ 1965 to 1994 Cushman Turf Truckster and 1965 to 1994 Haulster +++ 1990 to 1994 GT1 and F2 and F2J up to 1994 +++ Other Cushman models as well.
Part Number: BK33-023
|
|
|
Parking Brake Strut and Lever Assembly for Cushman Titan +++ 1976 to 2000 E-Z-GO Industrial Vehicles and Personnel Carriers models 875, X1-875, X1-875P, 881, 955, and 957 +++ 1989 to 1990 E-Z-GO GXT-1800 and GXI-1500 with Onan engine +++ 1993 and newer Columbia Par Car BC2, BC3 and BC4 Burden Carrier, Summit, EU24 and other utility vehicles +++ Taylor-Dunn model G-150 and optional on R-380 +++ Motrec models E-300, E-302, E-330, E-348 and others +++ Jacobsen Truck models 84005, 84006, 84013 and 84016 +++ EVI models 720 and 820 +++ Also Nordskog, Noland and Toro, and many other Industrial carts with Bendix Mechanical or Hydraulic Torque Spider Style Brakes.
Part Number: BK33-232
|
|
|
Parking Brake Strut and Lever Assembly Retaining Clip for 1974 to 1982 E-Z-GO Marathon and 1976 to 2000 E-Z-GO Industrial Vehicles and Personnel Carriers models 875, X1-875, X1-875P, 881, 955, and 957 +++ 1989 to 1990 E-Z-GO GXT-1800 and GXI-1500 with Onan engine +++ 1993 and newer Columbia Par Car BC2, BC3 and BC4 Burden Carrier, Summit, EU24 and other utility vehicles +++ Taylor-Dunn model G-150 and optional on R-380 +++ Motrec models E-330 and E-348 and others +++ EVI models 720 and 820 +++ Also Nordskog, Jacobsen, Cushman, Noland and Toro +++ Also Legend EV3-01 and EV4-01 and many other Industrial carts with Bendix Mechanical or Hydraulic Torque Spider Style Brakes.
Part Number: BK33-233
|
|
|
Rocker Arm Support for 1985 to 1996 Yamaha G2, G5, G8, G9, G11 and G14 with 4 cycle engine +++ As well as 1986 to 1997 Taylor-Dunn model R-680 engine
Part Number: EN99-380
|
|
|
Rocker Arm Shaft for 1985 to 2011 Yamaha G2, G5, G8, G9, G11, G14, G16, G20, G21, G22, G23, G27, G28 and G29 YDRA "The Drive" with 4 cycle engine +++ Also for 1986 to 1997 Taylor-Dunn model R-680 engine.
Part Number: EN99-390
|
|
|
Two Terminal,12 Volt Chrome Horn with adjustable decibel level.
Part Number: AC11-220
|
|
|
Sealed Horn or Brake Stop Light Switch +++ Can be used as replacement horn switch on E-Z-GO as well as Nordco Marketeer model 150 and Nordskog models 280 and 282 and others +++ NOTE: Uses 5/8" diameter mounting hole.
Part Number: AC11-200
Retail: |
$26.79 |
On Sale: |
$13.41 |
You Save: |
50% |
|
|
|
NOW AVAILABLE +++ 30 degree Potentiometer for 1995 and newer Cushman Minute Miser models 898320 and 898320A and early 898320B +++ Also used on 1995 and newer Tug model 898340A +++ Also 1995 and newer Titan models 898336B, 898341B, 898349B, 898351B, 898352, 898353, 898353EE, 898354, 898354EE, 898355, 898355EE, 898356, 898356EE, 898357, 898357EE.
Part Number: SP33-500
Retail: |
$246.82 |
On Sale: |
$143.21 |
You Save: |
42% |
|
|
|
NO LONGER AVAILABLE +++ Oil Pump for 1979 to 1981 Yamaha G1.
Part Number: EN99-530
|
|
|
Flexible Steering Shaft for 1988 to 2000 Columbia Par Car.
Part Number: ST11-700
|
|
|
CURRENTLY ON BACK ORDER +++ Rocker Arm for 1985 to 1996 Yamaha G2, G5, G8, G9, G11 and G14 with 4 cycle engine +++ Also for 1986 to 1997 Taylor-Dunn model R-680 engine.
Part Number: EN99-400
|
|
|
Exhaust Sealing Ring for 1979 to 1986 Yamaha G1 golf cart and G3 Sun Classic with J10, J17, J24, J31 or J42 two cycle engine
Part Number: MU99-122
Retail: |
$12.34 |
On Sale: |
$9.73 |
You Save: |
22% |
|
|
|
King Pin Spindle Bearing for Melex models 512 and 625.
Part Number: BE66-520
|
|
|
King Pin Spindle Bearing Seal for Melex models 512 and 625.
Part Number: BE66-530
|
|
|
Left Drivers Side Spindle for Melex models 512 and 625 +++ Also 1999 Taylor-Dunn model ER-200 Rover.
Part Number: ST66-200
|
|
|
Right Passenger Side Spindle for Melex models 512 and 625 +++ Also 1999 Taylor-Dunn model ER-200 Rover.
Part Number: ST66-210
|
|
|
Inner Seal for Front Hub on for Melex models 512 and 625.
Part Number: BE66-580
|
|
|
Upper Thick King Pin Steel Spacer Bushing for Melex models 512 and 625.
Part Number: BE66-540
|
|